Canon iP6700D - PIXMA Color Inkjet Printer Printing Manual page 71

Error message on camera
No ink
Ink Error
Hardware Error
Printer error
*1
To resume printing, you can press the OK
*2
The ink absorber absorbs ink used during cleaning, for example. If this message appears, you
will need to call for servicing to replace the absorber and to check the printer for proper
operation.
You can check the printer status according to the way the ink tank lamps (red)
flash. Check the status of the lamp and take the appropriate action to clear the
error.
When the ink tank lamp is off, possible causes are as follows:
• The ink tank may not be installed properly.
Install the appropriate ink tank.
• The ink tank may not be compatible with this printer.
Install the appropriate ink tank.
See "Replacing an Ink Tank" on page 48.
When the ink tank lamp flashes fast (at about one second interval), possible
causes are as follows:
• The ink has run out.
Replace the ink tank, and close the cover.
If printing is in progress and you want to continue printing, select Continue
in the display on your camera with the ink tank installed. Then printing can
continue under the ink out condition. Replace the empty ink tank immediately
after the printing. The printer may be damaged if printing is continued under
the ink out condition.
If multiple ink tank lamps are flashing, check how fast they flash. Fast flashing
(at about one second interval) indicates the ink is empty. Slow flashing (at
about three second interval) indicates ink is low. For details on different
flashing speeds, see "Getting the Ink Level Information" on page 48.
• Some ink tanks are not installed in place, or more than one ink tanks of the
same color are installed.
Confirm that the ink tanks are installed in the appropriate positions.
See "Replacing an Ink Tank" on page 48.
An ink tank that was once empty is installed.
Replace the ink tank and close the cover.
Printing with an ink tank that was once empty may damage the printer.
If you want to continue printing in this condition, you need to release the function
for detecting the remaining ink level. Press and hold the Stop/Reset
least 5 seconds, and then release it.
* With this operation, releasing the function for detecting the remaining ink level is
memorized. Please be advised that Canon shall not be liable for any printer
malfunction or damage caused by refilled ink tanks.
The ink tank errors have occurred.
Replace the ink tank.
See "Replacing an Ink Tank" on page 48.
An error requiring servicing might have occurred. (Printer POWER
lamp flash alternately.)
Disconnect the cable between the printer and the camera, turn off the printer, and
unplug the power cord of the printer from the power supply. After a while, plug the
power cord of the printer back in, turn on the printer, and then reconnect the
camera to the printer.
If the same error occurs, contact the Customer Care Center.
OK button on the printer instead of selecting Continue OK OK
Try This
Stop/Reset button for at
Stop/Reset Stop/Reset
POWER lamp and Alarm
POWER POWER
*1
Continue Continue Continue
Alarm
Alarm Alarm
Continue. Continue Continue
69