Canon iP6700D - PIXMA Color Inkjet Printer Printing Manual page 61

Message
The following ink tank cannot be
recognized.
U140
U043
The following ink tank cannot be
recognized.
U150
Error code
Adjusting the Print Head Manually
If the automatic print head adjustment does not work or if you wish to adjust
the print heads manually, follow the procedure below.
1. With the printer on, load two sheets of A4/Letter-sized plain paper in the
auto sheet feeder or cassette.
2. Press the Feed Switch
paper.
3. Press the Menu
4. Use the
button.
5. Use the
6. Use the
button.
7. When the confirmation message is displayed, use the
Yes and then press the OK Yes Yes Yes
The print head alignment pattern will be printed.
8. The message of "Did the patterns print correctly?
Ensure that the patterns were printed normally and use the
select Yes
Possible causes are as follows:
• The ink tank may not be installed properly (The lamp on the ink tank is off).
Install the appropriate ink tank.
• The ink tank may not be compatible with this printer (The lamp on the ink tank is
off).
Install the appropriate ink tank.
See "Replacing an Ink Tank" on page 48.
Ink tank errors have occurred (The lamp on the ink tank is off).
Replace the ink tank.
See "Replacing an Ink Tank" on page 48.
An error that requires contacting the Customer Care Center may have occurred.
(POWER POWER lamp and Alarm
POWER POWER
Disconnect the printer cable from the printer, and then turn the printer off and
unplug the printer from the power supply. Plug the printer back in and turn the
printer back on after leaving it for a while.
If the problem remains, contact the Customer Care Center.
Feed Switch Feed Switch button to select the paper source in which you loaded Feed Switch
Menu button.
Menu Menu
buttons to select Maintenance/settings
buttons to select Maintenance
buttons to select Manual head align
OK button. OK OK
Did the patterns print correctly?" is displayed on the LCD. Did the patterns print correctly? Did the patterns print correctly?
Yes Yes Yes and then press the OK
9. Examine the printed pattern and enter the number of
column "A" with fewest white stripes using the
buttons.
10. Use the
and use the
fewest white stripes.
11. Repeat same procedure and enter the pattern
numbers up to column "J".
12. After setting the number of all column, press the OK
button.
Try This
Alarm lamp flash alternately.)
Alarm Alarm
Maintenance/settings and then press the OK Maintenance/settings Maintenance/settings
Maintenance and then press the OK
Maintenance Maintenance
Manual head align and then press the OK Manual head align Manual head align
OK button. OK OK
button and move the cursor to column "B",
buttons to select the number with
OK OK OK
OK button.
OK OK
OK OK OK
buttons to select
buttons to
OK OK OK
59