IBM 79463AU Installation And User Manual page 28

v Backup basic input/output system switching under the control of the Integrated
v Built-in monitoring for fan, power, temperature, voltage, and power-supply
v Cable-presence detection on most connectors
v Chipkill memory protection
v Diagnostic support for ServeRAID and Ethernet adapters
v Error codes and messages
v Error correcting code (ECC) L2 cache and system memory
v Hot-swap cooling fans with speed-sensing capability
v Hot-swap hard disk drives
v Information and light path diagnostics LED panels
v Integrated Management Module (IMM)
v Menu-driven setup, system configuration, and redundant array of independent
v Microprocessor built-in self-test (BIST), internal error signal monitoring,
v Memory mirroring support (memory mirroring are mutually exclusive of each
v Parity checking on the small computer system interface (SCSI) bus and PCI
v Power management: Compliance with Advanced Configuration and Power
v Power-on self-test (POST)
v Predictive Failure Analysis (PFA) alerts on memory, SAS/SATA hard disk drives,
v Redundant Ethernet capabilities with failover support
v Redundant hot-swap power supplies and redundant hot-swap fans
v Redundant Network Interface Card (NIC) support
v Remind button to temporarily turn off the system-error LED
v Remote system problem-determination support
v ROM-based diagnostics
v ROM checksums
v Serial Presence Detection (SPD) on memory, VPD, power supply, and hard disk
v Single-DIMM isolation of excessive correctable error or multi-bit error by the
v Standby voltage for system-management features and monitoring
v Startup (boot) from LAN through remote initial program load (RIPL) or dynamic
v System auto-configuring from the configuration menu
v System-error logging (POST and IMM)
v Systems-management monitoring through the Inter-Integrated Circuit (IC)
v Upgradeable POST, Unified Extensible Firmware Interface (UEFI), diagnostics,
v Vital product data (VPD) on microprocessors, system board, power supplies, and
v Wake on LAN capability
12
IBM System x3550 M2 Types 4198 and 7946: Installation and User's Guide
Management Module (IMM)
redundancy
disks (RAID) configuration programs
configuration checking, and microprocessor and voltage regulator module failure
identification through light path diagnostics
other)
buses
Interface (ACPI)
fans, and power supplies
drives backplane
Unified Extensible Firmware Interface (UEFI)
host configuration protocol/boot protocol (DHCP/BOOTP)
protocol bus
IMM firmware, and read-only memory (ROM) resident code, locally or over the
LAN
SAS/SATA (hot-swap hard disk drive) backplane