Table 5.14 Selective Self-Test Feature Flags - Fujitsu MHT2080AH - 80GB 5400 RPM PATA Hard Drive Product Manual

Interface
Bit
0 Vendor specific (unused)
1 When set to one, perform off-line scan after selective test
2 Vendor specific (unused)
3 When set to one, off-line scan after selective test is pending.
4 When set to one, off-line scan after selective test is active.
5...15 Reserved
Bit [l] shall be written by the host and returned unmodified by the device. Bit
[3:4] shall be written as zeros by the host and the device shall modify them as
the test progress.
Selective Self-test pending time [min]
The selective self-test pending time is the time in minutes from power-on to
the resumption of the off-line testing if the pending bit is set.
(30) SECURITY DISABLE PASSWORD (F6h)
This command invalidates the user password already set and releases the lock
function.
The host transfers the 512-byte data shown in Table 5.15 to the device. The
device compares the user password or master password in the transferred data
with the user password or master password already set, and releases the lock
function if the passwords are the same.
Although this command invalidates the user password, the master password is
retained. To recover the master password, issue the SECURITY SET
PASSWORD command and reset the user password.
If the user password or master password transferred from the host does not match,
the Aborted Command error is returned.
Issuing this command while in LOCKED MODE or FROZEN MODE returns the
Aborted Command error.
(The section about the SECURITY FREEZE LOCK command describes
LOCKED MODE and FROZEN MODE.)
5-82

Table 5.14 Selective self-test feature flags

Description
C141-E195-02EN