Pedestal Mounting - Chamberlain LiftMaster Professional SW420 Installation Manual

PEDESTAL MOUNTING

1. Locate and anchor pedestal. Pedestal should be parallel and
square to the gate.
IMPORTANT NOTE: The distance between mounting pedestal and
the relative location of the operator to the gate and fence is
critical.
2. Locate electrical conduit, as required, prior to pouring
concrete.
3. Bolt the mounting brackets to the pedestal.
4. Secure the operator to the pedestal by dropping it onto the
pedestal and allowing the mounting studs to slip through the
holes on the pedestal brackets. Secure with hex nuts provided.
Figure 2
I N S T A L L A T I O N
Figure 1
Pedestal Mount Kit 65RSWP
Power and Control Wiring
Should Be Run In Separate
Conduit
Concrete Pad
2" to 4"
(5.1 to 10.2 cm)
Above Grade
Depth Required By
Local Codes or
Below Frost Line
11
Hinge Pin
Pivot
Gate
14"
26"
Parallel Mount
Pivot Hinge Pin
Gate
14"
26"
Pedestal 24" Deep
In-Ground Minimum
Perpendicular Mount
Nut (8x)
Bolt (4x) From Bracket to Pedestal
Fence Line
Fence Line