GS108T and GS110TP Smart Switch Software Administration Manual
To configure the network information for the management interface:
Select the appropriate radio button to determine how to configure the network
1.
information for the switch management interface:
Dynamic IP Address (DHCP). Specifies that the switch must obtain the IP address
•
through a DHCP server.
Dynamic IP Address (BOOTP). Specifies that the switch must obtain the IP address
•
through a BootP server.
Static IP Address. Specifies that the IP address, subnet mask, and default gateway
•
must be manually configured. Enter this information in the fields below this radio
button.
If you selected the Static IP Address option, configure the following network information:
2.
IP Address. The IP address of the network interface. The factory default value is
•
192.168.0.239. Each part of the IP address must start with a number other than zero.
For example, IP addresses 001.100.192.6 and 192.001.10.3 are not valid.
Subnet Mask. The IP subnet mask for the interface. The factory default value is
•
255.255.255.0.
Default Gateway. The default gateway for the IP interface. The factory default value
•
is 192.168.0.254.
Specify the VLAN ID for the management VLAN.
3.
The management VLAN is used to establish an IP connection to the switch from a
workstation that is connected to a port in the same VLAN. If not specified, the active
management VLAN ID is 1 (default), which allows an IP connection to be established
through any port.
When the management VLAN is set to a different value, an IP connection can be made
only through a port that is part of the management VLAN. It is also mandatory that the
Chapter 2: Configuring System Information
| 35