NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual page 247

GS108T and GS110TP Smart Switch Software Administration Manual
Destination MAC Mask: 00:00:00:00:FF:FF
•
Source MAC: 02:02:1A:BC:DE:EF
•
Source MAC Mask: 00:00:00:00:FF:FF
•
VLAN ID: 2
•
For more information about MAC ACL rules, see
From the MAC Binding Configuration screen, assign the Sales_ACL to the interface gigabit
3.
ports 6, 7, and 8, and then click Apply (See
You can assign an optional sequence number to indicate the order of this access list
relative to other access lists if any are already assigned to this interface and direction.
The MAC Binding Table displays the interface and MAC ACL binding information (See
4.
Binding Table
The ACL named Sales_ACL looks for Ethernet frames with destination and source MAC
addresses and MAC masks defined in the rule. Also, the frame must be tagged with VLAN ID
2, which is the Sales department VLAN. The CoS value of the frame must be 0, which is the
default value for Ethernet frames. Frames that match this criteria are permitted on interfaces
6, 7, and 8 and are assigned to the hardware egress queue 0, which is the default queue. All
other traffic is explicitly denied on these interfaces. To allow additional traffic to enter these
ports, you must add a new permit rule with the desired match criteria and bind the rule to
interfaces 6, 7, and 8.
on page 186).
on page 183.
MAC Rules
MAC Binding Configuration
Appendix B: Configuration Examples
on page 184).
MAC
| 247