NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual page 256

In the Guest VLAN field for ports g5–g8, enter 150 to assign these ports to the guest VLAN.
3.
You can configure additional settings to control access to the network through the ports.
See
Port Security Interface Configuration
Click Apply.
4.
From the 802.1X Configuration screen, set the Port Based Authentication State and Guest
5.
VLAN Mode to Enable, and then click Apply (See
page 175).
This example uses the default values for the port authentication settings, but there are
several additional settings that you can configure. For example, the EAPOL Flood Mode
field allows you to enable the forwarding of EAPoL frames when 802.1X is disabled on
the device.
From the RADIUS Server Configuration screen, configure a RADIUS server with the
6.
following settings:
Server Address: 192.168.10.23
•
Secret Configured: Yes
•
Secret: secret123
•
Active: Primary
•
For more information, see
Click Add.
7.
From the Authentication List screen, configure the default List to use RADIUS as the first
8.
authentication method (See
This example enables 802.1X-based port security on the GS108T or GS110TP switch and
prompts the hosts connected on ports g5-g8 for an 802.1X-based authentication. The switch
passes the authentication information to the configured RADIUS server.
256 | Appendix B: Configuration Examples
GS108T and GS110TP Smart Switch Software Administration Manual
on page 176 for information about the settings.
RADIUS Configuration
Authentication List Configuration
Port Security Configuration
on page 147.
on page 155).
on