Lldp Port Settings - NETGEAR GS110TP - ProSafe Gigabit Smart Switch Software Administration Manual

GS108T and GS110TP Smart Switch Software Administration Manual

LLDP Port Settings

Use the LLDP Port Settings page to specify LLDP parameters that are applied to a specific
interface.
To display the LLDP Port Settings page, click SystemLLDP Advanced  LLDPPort
Settings.
To configure LLDP port settings:
Change the LLDP port settings described below:
1.
Interface. Specifies the port to be affected by these parameters.
•
Admin Status. Select the status for transmitting and receiving LLDP packets:
•
Tx Only: Enable only transmitting LLDP PDUs on the selected ports.
•
Rx Only: Enable only receiving LLDP PDUs on the selected ports.
•
Tx and Rx: Enable both transmitting and receiving LLDP PDUs on the selected
•
ports.
Disabled: Do not transmit or receive LLDP PDUs on the selected ports.
•
Management IP Address. Choose whether to advertise the management IP address
•
from the interface. The possible field values are:
Stop Advertise: Do not advertise the management IP address from the interface.
•
Auto Advertise: Advertise the current IP address of the device as the
•
management IP address.
Notification. When notifications are enabled, LLDP interacts with the Trap Manager to
•
notify subscribers of remote data change statistics. The default is Disabled.
Chapter 2: Configuring System Information | 61