Control Commands - Epson TM U295 - B/W Dot-matrix Printer Operator's Manual

Control Commands

HT
[Name]
[Format]
[Description] Moves the print position to the next horizontal tab position.
[Notes]
[Reference]
LF
[Name]
[Format]
[Description] Prints the data in the print buffer and feeds one line based on the
[Note]
[Reference]
FF
[Name]
[Format]
This command functions differently depending on the printer mode selected.
When standard mode is selected:
[Description] Prints the data in print buffer and ejects the sheet.
[Notes]
[Reference]
When page mode is selected:
5-2 Commands
Horizontal tab
ASCII HT
Hex 09
Decimal 9
• Horizontal tab positions are set with ESC D.
• Ignored unless the next horizontal tab position has been set.
• The default tab positions are at intervals of 8 characters in the
5 x 7 font 9th column, 17th column, 25th column,. . . ).
ESC D
Print and line feed
ASCII LF
Hex 0A
Decimal 10
current line spacing.
This command sets the print position to the beginning of the line.
ESC 2, ESC 3
Print and eject sheet (in standard mode)
Print and return to standard mode (in page mode)
ASCII FF
Hex 0C
Decimal 12
• When the eject length has been set by ESC C, the printer ejects the
sheet based on the current eject length. Otherwise, the printer
ejects the sheet completely. If a paper out is detected during
ejection, the printer stops ejecting the sheet even if the specified
amount of paper has not been ejected.
• The ejecting direction is specified by ESC F.
ESC F, ESC C