Epson TM U295 - B/W Dot-matrix Printer Operator's Manual page 58

ESC T n
[Name]
[Format]
[Range]
[Description] Selects the print direction and starting position in page mode.
n Print Direction
0, 48 Left to right
1, 49 Bottom to top
2, 50 Right to left
3, 51 Top to bottom
[Notes]
[Default]
ESC W xL xH yL yH dxL dxH dyL dyH
[Name]
[Format]
[Range]
[Description] Sets the position and the size of the printing area.
5-18 Commands
Select print direction in page mode
ASCII ESC
Hex 1B
Decimal 27
n 3
0
48 n 51
n specifies the print direction and starting position as follows:
Starting Position
Upper left
(A in the figure)
Lower left
(B in the figure)
Lower right
(C in the figure)
Upper right
(D in the figure)
• When the printing direction is changed, the printing direction and
print starting position for the data following are those specified by
n.
• Only setting of this command is effective in standard mode.
• If n is out of the specified range, this command is ignored.
n = 0
Set printing area in page mode
ASC II ESC
Hex 1B
Decimal 27
0 xL 255, xH=0, 0
dyL 255, 0 dyH 1 (Except for dxL=dxH=0 or dyL=dyH=0)
• When the horizontal print start position, vertical print start
position, horizontal length, and vertical length are defined as x0,
y0, dx (dot), dy (dot), respectively.
Each setting for the printable area is calculated as follows:
x0 = [(xL + xH
y0 = [(yL + yH
T n
54 n
n
84
W xL xH yL yH dxL dxH dyL dyH
57 xL xH yL yH dxL dxH dyL dyH
87 xL xH yL yH dxL dxH dyL dyH
yL 255, 0 yH 1, 0
256)]
256)]
A
Printing area
C
dxL 255, dxH=0, 0