Parallel / Ethernet Interface Model - Epson TM H6000 - B/W Direct Thermal Technical Reference Manual

Notes:
Changes in DIP switch settings (excluding switches 2-7 and 2-8, interface reset signals) are recognized only when
the printer power is turned on or when the printer is reset. If the DIP switch setting is changed after the printer
power is turned on, the change does not take effect until the printer is turned on again or is reset.
If you turn on DIP switch 2-7 or 2-8 while the printer power is turned on, the printer may be reset, depending on
the signal state. DIP switches should not be changed while the printer power is on.
If the print density is set to level 3 or 4, printing speed is usually reduced.
For a tip about print density, see "When Using Original Paper" on page 3-24.

3.4.4.3 Parallel / Ethernet interface model

DIP Switch 1
SW Function
1-1 Auto line feed
1-2 Receive buffer capacity
1-3~ Reserved
1-8
DIP Switch 2
SW Function
2-1 Handshaking
(BUSY condition)
2-2 Internal use (Do not
change setting.)
2-3 Print density (See the table below.)
2-4
2-5~ Internal use (Do not
2-6 change setting.)
2-7 Reserved (for serial
interface)
2-8 I/F pin 31 reset signal
(Do not change setting.)
Print density
Print Density
1 (Light)
2
3
4 (Dark)
3-22 Setup
ON OFF
Always enabled Always disabled
45 bytes 4KB
Fixed to OFF
ON OFF
Receive buffer full Offline or receive
buffer full
Fixed to OFF
Fixed to OFF
Fixed to OFF
Fixed to ON
SW 2-3
ON
OFF
ON
OFF
SW 2-4
ON
OFF
OFF
ON
Rev. A