Autocutter - Epson TM H6000 - B/W Direct Thermal Technical Reference Manual

Character structure:
Character size, characters per line
Standard
W x H in mm
{inches}
Font A 1.41 x 3.39
12 x 24 {.06 x .13"}
Font B 0.99 x 2.40
9 x 17 {.04 x .09"}
Kanji 3.39 x 3.39
12 x 24 {.13 x .13"}
* CPL = characters per line
* Space between characters is not included
* Characters can be scaled up to 64 times the standard size.
* When using Font B in a font mode such as emphasized mode, some words may be hard to read. Check the font
mode in advance when using Font B.

1.5.4.1 Autocutter

Partial cut: Cutting with one point left uncut
NOTES:1.To prevent dot displacement, after cutting, feed paper approximately 1 mm (14/360 inches) or more
before printing.
2.If the printer is stopped, you must feed paper over 40 mm (1.58 in.) before cutting
1-16 General Information
Font A: 12 24 (including 2-dot spacing in horizontal)
Font B: 9 17 (including 2-dot spacing in horizontal)
Kanji: 24 24
Font A is the default
Double-height
W x H in mm
CPL {inches} CPL
42 1.41 x 6.77 42
{.06 x .27"}
56 0.99 x 4.80 56
{.04 x .19"}
21 3.39 x 6.77 42
{.13 x .27"}
Double-width/
Double-width Double-height
W x H in mm W x H in mm
{inches} CPL {inches}
2.82 x 3.39 21 2.82 x 6.77
{.11 x .13"} {.11 x .27"}
1.98 x 2.40 28 1.98 x 4.80
{.08 x .09"} {.08 x .19"}
6.77 x 3.39 10 6.77 x 6.77
{.27 x .13"} {.11 x .27"}
CPL
21
28
21
Rev. A