System Board; Removing The System Board - Dell Inspiron One 2330 Owner's Manual

System Board

WARNING:
Before working inside your computer, read the safety information that
shipped with your computer and follow the steps in "Before You Begin" on page 11.
For additional safety best practices information, see the Regulatory Compliance
Homepage at dell.com/regulatory_compliance.

Removing the System Board

NOTE:
Your computer's Service Tag is stored in the system board. You must enter
the Service Tag in the BIOS after you replace the system board.
NOTE:
Before disconnecting the cables from the system board, note the location of
the connectors so that you can reconnect them correctly after you replace
the system board.
Prerequisites
1 Remove the stand. See "Removing the Stand" on page 19.
2 Remove the back cover. See "Removing the Back Cover" on page 23.
3 Remove the VESA-mount bracket.
See "Removing the VESA-Mount Bracket" on page 43.
4 Remove the system-board shield.
See "Removing the System-Board Shield" on page 49
5 Remove the memory modules.
See "Removing the Memory Module(s)" on page 35.
6 Remove the power-supply fan bracket.
See "Removing the Power-Supply Fan Bracket" on page 77.
7 Remove the B-CAS card. See "Removing the B-CAS Card" on page 25.
8 Remove the I/O cover. See "Removing the I/O Cover" on page 81.
9 Remove the I/O board shield.
See "Removing the I/O Board Shield" on page 85.
10 Remove the processor heat-sink.
See "Removing the Processor Heat-Sink" on page 65.
System Board
113