Problem Solving; Troubleshooting - Kyocera KM-F1060 Operating Instructions Manual

If You Have Any of These Problems
Mode
During Transmission
Transmitted Document
Quality
During Reception
No Machine Operation
112

Problem Solving

Troubleshooting

Symptom
Document doesn't feed/multiple
feed
Does not stamp
Stamp too light
Vertical lines on the transmitted
document
Transmitted document is blank
No recording paper
Recording paper misfed
Recording paper doesn't feed into
machine
Recording paper doesn't eject
after printing
Out of toner
No machine operation
Possible Cause / Action
1. Check that your document is free of
staples and paper clips, and that it is not
greasy or torn.
2. Check that your document is the right
type to send through an ADF by
consulting.
For more details see Operating
Instructions (For Facsimile and Copy
Functions)
3. Check that the document is loaded
properly.
Check Fax Parameter No. 4 and No. 28
settings.
Replace stamp or refill ink.
(See Operating Instructions (For Facsimile
and Copy Functions))
Check own copy quality. If copy is OK, your
machine has no problem, report to the
receiving party that they have a problem. If
copy is NG, clean the Document Scanning
Area.
Replenish the recording paper.
Remove the misfed paper.
(See Operating Instructions (For Facsimile
and Copy Functions))
Make sure that there is paper in the Paper
Cassette. Follow the instructions for loading
paper.
Check to see if the recording paper is
jammed inside of the machine.
Replace the Toner Container.
To reset the machine, turn "Off" the Power
Switch for a few seconds then turn it "On"
again.
Page
---
84
85
---
---
---
---
---
---
---
16