Connecting Component Input (480P/720P/1080P/1080I/480I) - HP LD4700 - Widescreen LCD Digital Signage Display User Manual

Press the INPUT button on the remote control to select the input signal. Press the SET button to
save your change.
Or, press the SOURCE button on the back side of the monitor panel. Press the AUTO/SET button
to save your change.
a.
b.
NOTE:
has a priority.

Connecting Component Input (480p/720p/1080p/1080i/480i)

1. Connect the video/audio cable (not included) as shown in the following illustration, and then
connect the power cord. Connect the Component1 (1) or Component2 (2) input terminal to the
monitor and HDTV receiver.
Figure 3-24
NOTE:
support HDCP.
2. Select an input signal.
Press the INPUT button on the remote control to select the input signal. Press the SET button to
save your change.
Or, press the SOURCE button on the back side of the monitor panel. Press the AUTO/SET button
to save your change.
a.
b.
16 Chapter 3 Setting Up the Monitor
When connecting with a BNC cable, select AV from the Input menu.
When connecting with an S-Video cable, select AV from the Input menu.
When the BNC cable is connected simultaneously with S-Video cable, the S-Video input
Connecting the BNC and Audio Cables to HDTV Receiver
Some devices may require HDCP in order to display HD signals. Component does not
Select Component1 from the Input menu.
Select Component2 from the Input menu.
ENWW