3
Setting Up the Monitor
To set up the monitor, ensure that the power is turned off to the monitor, computer system, and other
attached devices, then follow the instructions below.
Installing the Stand (Sold Separately)
1.
Remove the screws (1), monitor stand (2) and cable management clip (3) from the box.
NOTE:
screws.
Figure 3-1
Figure 3-2
4
Chapter 3 Setting Up the Monitor
The LD4200 stand uses six M4 x 12mm screws. The LD4700 stand uses four M4 x 26mm
LD4200 Stand Accessory Contents
LD4700 Stand Accessory Contents
ENWW