Figure 26. 1U Threaded Rack Adapter Brackets Kit; Figure 27. R410 Static Rails - Dell External OEMR R410 Technical Manual

Technical guide

Hide thumbs Also See for External OEMR R410:

Table of Contents

Dell

Depending on the depth of the rack used, it may be necessary to remove the server's bezel in order

to close the door of the rack. A minimum of 58 mm will be needed between the back surface of the

door panel and the front face of the EIA flange for the front door to close with the 11G server bezel

installed.

Figure 26. 1U Threaded Rack Adapter Brackets Kit

The static rails support a wider variety of racks than the sliding rails but do not support

serviceability in the rack and are thus not compatible with the CMA.

One key factor in selecting the proper rails is identifying the type of rack in which they will be

installed. Both the sliding rails and the static rails support mounting in 19‖-wide, EIA-310-E

compliant 4-post racks, but only the static rails, as the more generic or ―universal‖ solution, support

mounting in 2-post (Telco) racks.

PowerEdge R410 Technical Guide

Table of Contents

Do you have a question about the External OEMR R410 and is the answer not in the manual?

Poweredge r410