Animate Results - Autodesk 466B1-05A761-1304 - AutoCAD Inventor Simulation Suite 2010 Getting Started Manual

3rd Principal Stress
The 3rd principal stress acts normal to the plane in which shear stress is zero.
It helps you understand the maximum compressive stress induced in the part
due to the loading conditions.
Displacement
The Displacement results show you the deformed shape of your model after
the solution. The color contours show you the magnitude of deformation
from the original shape. The color contours correspond to the values defined
by the color bar.
Safety Factor
Safety factor shows you the areas of the model that are likely to fail under
load. The color contours correspond to the values defined by the color bar.
Frequency Modes
You can view the mode plots for the number of natural frequencies that you
specified in the solution. The modal results appear under the Results node in
the browser. When you double-click a frequency mode, the mode shape
displays. The color contours show you the magnitude of deformation from
the original shape. These are modal deformations and their magnitude is
relative and cannot be taken as the actual deformation. The frequency of the
mode shows in the legend. It is also available as a parameter.

Animate Results

Use Animate Displacement to visualize the part through various stages of
deformation. You can also animate stress, safety factor, and deformation under
frequencies.
Animate Results | 27