Edit The Color Bar - Autodesk 466B1-05A761-1304 - AutoCAD Inventor Simulation Suite 2010 Getting Started Manual

Probe for values at specific points.

Edit the Color Bar

The color bar shows you how the contour colors correspond to the stress
values or displacements calculated in the solution. You can edit the color bar
to set up the color contours so that the stress/displacement is displayed in a
way that is meaningful to you.
Edit the color bar
1 On the ribbon, click Stress Analysis tab
By default, the maximum and minimum values shown on the color bar
are the maximum and minimum result values from the solution. You
can edit the maximum and minimum values to adjust the way the bands
appear.
2 To edit the maximum and minimum critical threshold values, clear the
check box next to the item you want to modify. Edit the values in the
text box. Click OK to complete the change.
To restore the default maximum and minimum critical threshold values,
check the corresponding box next to the item.
The levels are initially divided into seven equivalent sections, with default
colors assigned to each section. You can select the number of contour
colors in the range of 2 to 12.
When using smooth shading, only 5 colors are used and these controls
are disabled.
3
and Decrease Colors. You can also enter the number of colors you want
in the text box.
4
of gray. To view result contours on the grayscale, click Grayscale under
Color Type.
NOTE It does not work for safety factor.
To increase or decrease the number of colors, click Increase Colors
You can view the result contours in different colors or in shades
Display panel Color Bar.
Edit the Color Bar | 25