Easy Setup; Advanced Setup - Sony LocationFree LF-PK1 Operating Instructions Manual

Problem
Authentication of the user name and
password for opening the setup screen
fails.
Forgot the password for opening the
setup screen.

Easy Setup

Problem
NETWORK LED of the Base Station
does not light up.
NETAV LED of the Base Station blinks
amber, then does not turn off but stays lit
amber.
The [NetAV Check] page does not
appear.
The NetAV Check failed.
NetAV LED stays green.

Advanced Setup

Problem
The setup screen disappears soon after
configuring settings.
• For questions about Internet connections, contact your Internet Service Provider (ISP) or cable TV company.
• LocationFree Support web site: http://www.sony.net/Products/LocationFree/support/
Causes and remedies
• Did you enter uppercase letters instead of lowercase letters, or vice
versa? The Base Station distinguishes between uppercase and
lowercase letters.
• Did you enter the correct user name? The user name is lfx (lowercase
letters).
• Did you enter the correct password? The default password is printed on
the label on the side of the Base Station.
• The default password is printed on the label on the side of the Base
Station.
• If you changed the password and forgot the new password, the Base
Station will need to be initialized (1 page 48). After initializing the
Base Station, enter the password printed on the label on the side of the
Base Station.
Causes and remedies
Check the "NETWORK LED on the Base Station does not turn on"
(1 page 50) section of "Base Station."
Make sure the modem and router are turned on and connected properly.
Check the "NETWORK LED on the Base Station does not turn on"
(1 page 50) section of "Base Station."
Check the settings in accordance with the information displayed on the
[NetAV Check] page, then perform the test again.
Another device is connected by NetAV.
Causes and remedies
• If you change the IP address of [Internet Connection] while using a
wired LAN to configure the Base Station settings, the setup screen will
no longer be able to be accessed. If this happens, select [Base Station
Settings] from the [Base Station Selection] window and reset the
setting.
• The Base Station is restarted automatically when you click [Exit
Setup]. Perform the following operation to check the Base Station
settings again.
When connected to the Base Station via a wireless
connection:
Try establishing a wireless connection to the Base Station again and
then click [Base Station Settings] from the [Base Station Selection]
screen.
When connected to the Base Station via a wired LAN:
Switch the Base Station to setup mode, then click [Base Station
Settings] from the [Base Station Selection] screen.
54