Download  Print this page

Sony LocationFree LF-PK1 Operating Instructions Manual Page 9

Locationfree base station locationfree player for pc.
Hide thumbs


Connecting the IR Blaster
Attach the supplied IR Blaster to the device
connected to the Base Station.
You can control the device with the LocationFree
device's on-screen remote control via the IR
to IR BLASTER port
With reference to the operating instructions of the
device, make sure to place the IR Blaster just
above the remote sensor.
Do not remove the backing paper from the IR Blaster
After configuring LocationFree Player remote control
settings (1 page 28), remove the backing paper from
the IR Blaster and fix it in place.
IR Blaster
Infrared transmitter
Remote sensor
When operating two devices with the IR Blaster,
set the devices and the IR Blaster as shown.
IR Blaster
Remote sensors
For details on setting up a device, refer to the operating
instructions of the device.
If the remote sensors on the two devices do not
line up like the picture above, you cannot control
them with the single supplied IR Blaster, and you
need to purchase a 3.5 mm jack splitter, such as
Sony Headphone Adapter PC-232S (not
supplied), and another IR Blaster. Connect the
plug adapter to the IR BLASTER port on the
Base Station and connect each IR Blaster to a port
on the adapter plug.
• If the IR Blaster cable is too short, use the 3.5 mm
jack extension cable (not supplied).
• Remote sensors on Sony Recorders and other
products are identified with the
• You can set up two on-screen remote controls for
each video input connector. These on-screen remote
controls allow you to operate two devices connected
directly to the Base Station, and to control video
input via those devices.


Table of Contents

   Related Manuals for Sony LocationFree LF-PK1

This manual is also suitable for:

Locationfree lf-b1Locationfree lfa-pcv2

Comments to this Manuals

Symbols: 0
Latest comments: