Eagle FishElite 480 Installation And Operation Instructions Manual page 86

In manual mode, you have complete control over sensitivity, with the
ability to set it anywhere from zero to 100 percent. Once you select a
level in manual, the unit will continue to use that exact sensitivity set-
ting until you change it or revert to auto mode.
To adjust sensitivity in auto mode:
1. Press
MENU
2. The Sensitivity Control Bar appears. Press ↓ to decrease sensitivity;
press ↑ to increase sensitivity. When it's set at the desired level, press
. (When you reach the maximum or minimum limit, a tone sounds.)
EXIT
At left, Sonar Menu with Sensitivity command selected. At right, the
To adjust sensitivity in manual mode:
1. First, turn off Auto Sensitivity: from the Sonar Page, press
to
A S
UTO ENSITIVITY
2. Press ↑ to
Press ↓ or ↑ to pick a different sensitivity setting. When it's set at the
desired level, press
To turn Auto Sensitivity back on:
From the Sonar Page, press
NOTE:
To return to the original factory setting for Auto Sensitivity, see the
entry in this section on Reset Options. If sensitivity is in manual
mode, the Reset Options command will switch back to Auto and re-
set the factory setting at the same time.
Tip:
For quicker sensitivity adjustments, try leaving the Sensitivity
Control Bar on the screen as the chart scrolls. You can see the
| .
ENT
Sensitivity Control Bar.
| .
ENT
|
S ENT
ENSITIVITY
.
EXIT
and the Sensitivity Control Bar appears.
|↓ to
MENU A
UTO
78
|
S ENT
ENSITIVITY
|↓
MENU
| .
EXIT