Eagle IntelliMap 642c iGPS Installation And Operation Instructions Manual page 79

GPS Setup Menu (left). GPS Simulator menu (center).
Map Page showing Steer with Arrows dialog boxes (right). The trav-
eler is following a track of 144º at a speed of 71 miles per hour.
Choose the desired settings, then turn on the simulator by highlighting
the
GPS S
IMULATOR
back to the main page display. A message and tone appear periodically
to remind you the simulator is on. To turn off the simulator, repeat the
steps above or turn off the unit.
If you selected the Steer with Arrows command and want to remove the
dialog boxes from the screen, press
speed boxes without disrupting the simulation and allow you to use the
map cursor.
Simulating Trail or Route Navigation
In Simulator mode, your unit can automatically follow a trail or route
without manual steering if you use these steps:
1. From the Map Page, go to the simulator menu. Pick a
at or near the beginning of your trail/route. Enter an approxi-
P
OSITION
mate (shown in compass degrees) that will point you toward the
T
RACK
start of the trail/route.
2. Set to zero. Select
S
PEED
which turns on the simulator and returns you to the Map Page.
3. Begin navigating along the trail/route. (If you are close enough to the
first waypoint, the arrival alarm will usually go off as soon as naviga-
tion begins. Press
press ↑ to increase speed to the desired setting.
4. Press to turn off the steering and speed boxes. The unit will now
EXIT
automatically steer along the trail or route. When you arrive at your
destination, cancel navigation.
box and pressing
O
N
S
TEER WITH
to clear the alarm.) When navigation starts,
EXIT
. Press
ENT
. That will clear the track and
EXIT
command and press
A
RROWS
73
repeatedly to get
EXIT
S
TARTING
,
ENT