Eagle IntelliMap 642c iGPS Installation And Operation Instructions Manual page 54

Figure 1.
Figure 2.
Figure 4.
Figure 3.
Navigate a trail menu sequence: Fig. 1, My Trails command. Fig. 2,
Trails Menu. Fig. 3, Edit Trail Menu. Fig. 4, Edit Route Menu with
Navigate Route command highlighted for Trail 2. A trail is always con-
verted to a route when you navigate the trail.
On the Map Page, the trail you are navigating is represented by a ma-
genta line when the visible trail option is on. The course you are follow-
ing is represented by a red line. The magenta trail line overlays the red
course line. To see the red course line, you must turn off the visible trail
option. The Navigation Page will show only the red course line, unless
you are recording a new trail. The bearing arrow on the compass rose
points to the next waypoint on the trail.
As you travel, the arrival alarm will go off when you near a trail way-
point and the bearing arrow on the compass rose will swing around to-
ward the next trail waypoint. Press to clear the alarm.
EXIT
48