Garmin G900X Pilot's Manual page 50

DCLTR-1
SYSTEM OVERVIEW
DCLTR-2
DCLTR-3
OBS
CDI
DME
(optional)
XPDR
SYN VIS DFLTS
STBY
ON
ALT
GND
VFR
CODE
0 — 7
BKSP
IDENT
TMR/REF
NRST
PATHWAY SYN TERR HRZN HDG
ALERTS
0 1
34
TRFC-1
TRFC-2
Selects OBS Mode on the CDI when navigating by GPS (only available with active
PFD
leg)
Cycles through GPS, VOR1, and VOR2 navigation sources on the HSI
Displays the DME Tuning Window, allowing tuning and selection of the DME
(optional)
(optional)
Displays transponder mode selection softkeys:
DME
WIND BRG 1 HSI FMT
Selects standby mode (Transponder does not reply to any interrogations)
Selects Mode A (Transponder replies to interrogations)
Selects Mode C – altitude reporting mode (Transponder replies to identification and
altitude interrogations)
Manually selects Ground Mode (Transponder does not allow Mode A and Mode C
replies, but does permit acquisition squitter and replies to discretely addressed Mode
S interrogations)
360 HSI
Automatically enters the VFR code (1200 in U.S.A. only)
Displays transponder code selection softkeys 0-7
Use numbers to enter code
METERS
Removes numbers entered, one at a time
Activates the Special Position Identification (SPI) pulse for 18 seconds, identifying the
transponder return on the ATC screen
OPTN1 OPTN2 OPTN3 OFF
Displays/removes Timer/References Window
Displays/removes Nearest Airports Window
APTSIGNS
Displays/removes Alerts Window
STBY ON ALT GND
2 3 4 5
Figure 1-24 XPDR Softkeys
Garmin G900X Pilot's Guide
Press the BACK Softkey to return
to the top-level softkeys.
BRG 2 ALT UNIT
Press the BRG1/BRG2 Press the BACK Softkey to return
softkeys to display/remove to the top-level softkeys.
the Bearing Information
windows and cycle through
bearing sources:
- NAV1/NAV2
- GPS
ARC HSI
IN HPA
XPDR
VFR CODE IDENT
Press the BACK Softkey to return
to the top-level softkeys.
6 7 IDENT
Press the BACK Softkey to return
to the top-level softkeys.
STD BARO BACK ALERTS
BACK ALERTS
BACK ALERTS
BACK ALERTS
ALERTS
BACK ALERTS
BKSP BACK ALERTS
190-00726-00 Rev. J