Garmin G900X Pilot's Manual page 426

HAZARD AVOIDANCE
Vertically scanning a storm cell:
Vertical scanning of a storm cell should be done with the aircraft wings level to avoid constant
NOTE:
adjustment of the Bearing Line.
1) While in the Horizontal Scan view, press the BRG Softkey. This places the cursor in the BEARING field and
displays the Bearing Line.
If the Bearing Line is not displayed, press the MENU Key and turn the large FMS Knob to select Show Bearing
Line. Press the ENT Key.
2) Press the ENT Key.
3) Turn the small FMS Knob to place the Bearing Line on the desired storm cell or other area to be vertically
scanned.
4) Press the VERTICAL Softkey. A vertical slice of the selected area is displayed (Figure 6-106).
5) The small FMS Knob may be used to move the scanned slice a few degrees right or left.
6) Turn the RANGE Knob to adjust the range.
7) Press the FMS Knob to remove the cursor.
8) To select a new area to be vertically scanned, press the HORIZON Softkey to return to the Horizontal Scan view
and repeat the previous steps.
The RANGE Knob can also be used to adjust bearing from left to right.
410
Bearing Line
Scan Line
Figure 6-105 Bearing Line on Horizontal Scan
Garmin G900X Pilot's Guide
190-00726-00 Rev. J