Replacing Paper - Epson SureColor SC-T3000 User Manual

SC-T7000 Series/SC-T5000 Series/SC-T3000 Series User's Guide
A
Select an option.
To print at current settings
Press the d/u buttons to highlight Keep Settings
Above and press the Z button.
Proceed to Step 6.
To change settings
Press the d/u buttons to highlight Change
Settings and press the Z button.
B
Highlight a setting you wish to change and press
the Z button.
C
Highlight an option and press the Z button.
D
Press the y button to return to the dialog shown
in Step 2.
E
When settings are complete, highlight Exit and
press the Z button.
F
If On is selected for Remaining Setup, you will
be prompted to enter the length of the roll.
Press the d/u buttons to choose a value between
5.0 and 99.5 m and press the Z button. Paper
length is set in increments of 0.5 m.
After a short pause the printer will show Ready,
indicating that it is ready to print. Transmit the data to
be printed from a computer.
Basic Operations

Replacing Paper

This section describes how to replace paper. The process
for removing the current paper differs with the type of
paper loaded; follow the instructions displayed in the
control panel.
Buttons that are used in the following settings
A
Confirm that the printer is ready and press the
( button.
The Load/Remove Paper menu will be displayed.
B
Press the d/u buttons to select the type of paper
used to replace the current paper, and then press
the Z button.
C
The printer will eject the current paper.
The process for ejecting the paper varies with the
type of paper loaded, as described below.
If On is selected for Roll Paper Remaining
Barcode printing will begin; when printing is
complete, the roll will rewind automatically.
If Off is selected for Roll Paper Remaining
The roll rewinds automatically.
Note:
When the display shows Turn roll paper adapter
to wind up roll paper, open the roll paper cover and
rewind the paper by hand.
36