Notes On Handling Paper - Epson SureColor SC-T3000 User Manual

SC-T7000 Series/SC-T5000 Series/SC-T3000 Series User's Guide
❏ To ensure good results, use all the ink in the
cartridge within a year of installation.
❏ Ink cartridges that have been stored at low
temperatures for an extended period should be
allowed to return to room temperature over a
period of four hours.
❏ Do not touch the IC chips on the sides of ink
cartridges. You may not be able to print properly.
❏ Install all ink cartridges into each slot. You cannot
print if any of the slots are empty.
❏ Do not leave the printer without ink cartridges
installed. The ink in the printer may dry, preventing
it from printing as expected. Leave ink cartridges in
all slots even while you do not use the printer.
❏ The ink level and other data are stored in the IC
chip, allowing cartridges to be used after being
removed and replaced.
❏ To avoid getting dirt on the ink supply port, store
the removed ink cartridge properly. The ink supply
port has a valve in it so it does not need to be capped.
❏ Removed ink cartridges may have ink around the
ink supply port, so be careful not to get any ink on
the surrounding area when removing the
cartridges.
❏ To maintain the quality of the print head, this
printer stops printing before ink cartridges are
completely expended.
❏ Although the ink cartridges may contain recycled
materials, this does not effect printer function or
performance.
❏ Do not dismantle or remodel ink cartridges. You
may not be able to print properly.
❏ Do not drop or knock it against hard objects;
otherwise, the ink may leak.

Notes on handling paper

Note the following points when handling and storing
the paper. If the paper is not in good condition, print
quality may decline.
Check the documentation supplied with each paper.
Introduction
Notes on Handling
❏ Use Epson special media under normal room
conditions (temperature: 15 to 25˚C; humidity: 40
to 60%).
❏ Do not fold the paper or scratch the surface of the
paper.
❏ Avoid touching the printable surface of the paper
with your bare hands. Moisture and oils from your
hands can affect print quality.
❏ Handle paper by the edges. We recommend
wearing cotton gloves.
❏ Changes in temperature and humidity may cause
paper to become wavy or curled. Be careful not to
scratch or soil the paper, and flatten it before
loading it in the printer.
❏ Do not wet the paper.
❏ Do not throw away the paper packaging as you can
use it for storing the paper.
❏ Avoid locations that are subject to direct sunlight,
excessive heat, or humidity.
❏ Keep cut sheets in their original package after
opening, and keep them in a flat place.
❏ Remove roll paper that is not in use from the
printer. Rewind it correctly and then store it in the
original packaging that came with the roll paper. If
you leave the roll paper in the printer for a long
time, its quality may decline.
Notes on handling printed paper
To maintain long lasting, high quality print results, note
the following points.
❏ Do not rub or scratch the printed surface. If they are
rubbed or scratched, the ink may peel off.
❏ Do not touch the printed surface; Failure to observe
this precaution may cause ink to rub off.
❏ Make sure the print outs are completely dry before
folding of stacking; otherwise, the color may change
where they touch (leaves a mark). These marks will
disappear if they are separated immediately and
dried; however, they will remain if not separated.
19