Table of Contents
Advertisement
2.2
LSI Corporation MPT Setup Utility
The LSI Corporation MPT Setup Utility is an integrated RAID solution that allows
you to create the following RAID sets from SAS hard disk drives supported by the
LSI SAS 2008 Series controller: RAID 0, RAID 1, RAID 1E, and RAID 10.
•
You may use disks of different sizes in one volume; however, the size of the
smallest disk determines the "logical" size of each member disk.
•
DO NOT combine Serial ATA and SAS disk drives in one volume.
•
The RAID setup screens shown in this section are for reference only and
may not exactly match the items on your screen due to the controller
version difference.
•
The adapter name shown on the setup screens differs according to the
installed SAS RAID card.
•
Before requesting support from the ASUS Technical Support team, you
have to take note of the MPTFW and MPTBIOS version for the SAS RAID
card. After entering the SAS configuration utility, you can see below screen
and identify the MPTFW and MPTBIOS version:
MPTFW version: 5.00.00.00-IR
MPTBIOS version: v7.05.01.00 (2010.02.09)
LSI Corp Config Utility
Adapter List
Adapter
PIKE 2008
Esc = Exit Menu
Alt+N = Global Properties
ASUS PIKE 2008
v7.05.01.00 (2010.02.09)
Global Properties
PCI
PCI
PCI
BUS
Dev
Fnc
04
00
00
F1/Shift+1 = Help
-/+ = Alter Boot Order
PCI
FW Revision
Slot
07
5.00.00.00-IR
Ins/Del = Alter Boot List
Status
Boot
Order
Enabled
0
2-3
Advertisement
Table of Contents
