Deleting A Network Portal - D-Link DSN-5410-10 - xStack Storage Area Network Array Hard Drive Software Manual

3. In the IP Address field, enter the IP address for the network portal. The IP address must
be a unique address that is different than the management port and reside on the same
subnet as the iSCSI initiator.
4. In the Subnet Mask field, enter a subnet mask for the network portal.
5. In the Gateway field, enter the default gateway, if appropriate.
6. If the selected Ethernet port is part of a VLAN, use the VLAN id field to specify the ID of
the VLAN to which this portal will belong, within the range of 2 through 4094. A value of
cannot be set to 1, since it is reserved.
7. Click the OK button.
The network portal appears below the selected Ethernet port in the Main Display.

7.4.2 Deleting a Network Portal

If you no longer need a network portal, use the following procedure to delete it.
1. In the Network Settings View, click an IP address in the Main Display for the network
portal you want to delete.
2. Perform one of the following steps:
On the Network menu, click Delete Portal.
–
In the System Actions panel, click Delete Portal.
–
Press the right mouse button and click Delete Portal from the shortcut menu.
–
Any of these steps displays the message in Figure 7-6.
110 Chapter 3 Managing Volumes
Figure 7-5. Create Portal dialogs
If the selected Ethernet port is not part of a VLAN, the VLAN ID field is not
present in the Create Portal dialog box.