Restoring A Configuration (Control Tab) - D-Link DSN-5410-10 - xStack Storage Area Network Array Hard Drive Software Manual

6. Record the information in Table C-7.

6.2.6 Restoring a Configuration (Control Tab)

If you used the procedure in section 6.2.5 to save the xStack Storage configuration, you can
use the following procedure to restore the configuration.
1. In the System Administration View, click the Control tab.
2. Under XStack Storage Configuration, click the Restore button.
The Open dialog box appears (see Figure 6-11).
3. Using the Open dialog box, go to the location where you stored the configuration file.
4. Click the file and click the Open button.
The precautionary message shown in Figure 6-12 appears.
5. Click OK to restore the configuration and reboot the xStack Storage, or click Cancel to
keep the current configuration and not reboot the xStack Storage.
xStack Storage Management Center Software User's Guide
We recommend you write the name and location of the configuration file in
case you need to use it to restore your xStack Storage's configuration.
Figure 6-11. Open Dialog Box
If you recorded the name and location of the configuration file in Table C-7,
refer to this table for reference
Figure 6-12. Precautionary Message
91