D-Link DSN-5410-10 - xStack Storage Area Network Array Hard Drive Software Manual page 54

8. If you are satisfied with your selections, click Finish to create the volume. Otherwise,
click the Back button to return to the screen where you need to change a selection.
Then click Next until you return to this screen and click Finish to create the volume.
If the volume is created, a message similar to the one in Figure 4-12 appears.
9. Click Close to close the Wizard and return to the Volume View.
44 Chapter 4 Managing Volumes
Figure 4-11. Ready to Create Volume Screen
Figure 4-12. Successfully Created Volume Message