Scanning A Volume - D-Link DSN-5410-10 - xStack Storage Area Network Array Hard Drive Software Manual

4.3.2 Scanning a Volume

After you create a volume, you can scan it for errors. This task reads every block in the
volume to ensure that parity and media are correct. If parity errors are found, this task
corrects the errors.
To scan a volume:
1. In the Volume View, click a volume in the Main Display.
2. Perform one of the following steps:
On the Volumes menu, click Scan Volume.
–
Click Scan Volume in the Volume Actions panel.
–
Press the right mouse button and click Scan Volume from the shortcut menu.
–
Any of these steps displays the Scan Volume dialog box (see Figure 4-22).
3. To scan the selected volume now, be sure Scan Volume now is selected. Skip to step 5.
4. To scan the selected volume at a later time, click Scan Volume later. Then:
Under Scan Frequency, specify how often the scan is to be performed.
–
Click the icon next to the right of the Date and time drop-down list and select a
–
date and time from the pop-up calendar (see Figure 4-23).
5. Click OK.
6. Record the scheduled task in Table C-5.
xStack Storage Management Center Software User's Guide
Figure 4-22. Scan Volume Dialog Box
If you schedule the scan, you can use the Schedule tab in the System
Administration View to view, suspend, or delete this scheduled action (see
section 6.2.4).
53