Table of Contents
Advertisement
Switching the dishwasher ON
Turn on the tap.
Open the door.
Set ON-OFF button
"I" to ON.
Press programme button "B" , programme indicator
"
A"
lights and the time-remaining indicator "
plays the time of the programme..
If the door is closed, the programme indicator "A" be-
comes to light and the dishwasher beeps one time ,
then the programme starts automatically.
End of programme
Six beeps will indicate that the wash cycle has finished.
Switching the dishwasher OFF
Several minutes after the programme has ended:
Open the door.
Set ON-OFF button " I " to OFF.
Remove dishes, etc. when they have cooled down.
Interrupping the programme
A
cycle that is underway can be modified if it has only been running for a short time. Otherwise, the
detergent may have already been used, and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled ( see the paragraph entitled, " Loading the
detergent ").
Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open
the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds.
If the appliance has already heated up or the hot water was switched ON and then the appliance door
opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may
open due to expansion.
F
" dis-
en
I
A
B
F
G
22
Advertisement
Table of Contents
