Washing Dishes; 13-1.Switching The Dishwasher On; 13-2.End Of Programme; 13-3.Switching The Dishwasher Off - Haier DW9-TFE3-F Service Manual

Service Manual
Model No: DW9-TFE3 Series

13.Washing dishes

13-1.Switching the dishwasher ON

● Close the door after loading the appliance.
● Set On-Off button "B" to On. The state indicator "A" light.
● Rotate the knob to select programme you wish, the timeremaining
indicator display the time of the programme you
selected. After 3 seconds the appliance emits a short warning
signal, and start the programme ,the state indicator "A"
blinks .
Warning
When the dishwasher power on, the programme which the knob indicated can not be
carried out, you must Rotate the knob to another programme and then back to it.

13-2.End of programme

● Six beeps will indicate that the wash cycle has finished and the state indicators "A" light.

13-3.Switching the dishwasher OFF

Several minutes after the programme has ended:
● Set On-Off button to Off
● Open the door .
● Remove dishes, etc. when they have cooled down.
Notice:
When the appliance is already underway press the button "B" for 3 seconds, all
of the settings will be cancelled.

13-4.Interrupping the programme

● Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not
open the door fully until spray arm has stopped rotating.
● When you open the door, the dishwasher will beep ten times every thirty seconds.
● If the appliance has already heated up or the hot water was switched ON and then the
appliance door opened, leave the door ajar for several minutes and then close. Otherwise, the
appliance door may open due to expansion.
27
Issue
Rev.