Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Haier DW12-CBE5
Summary of Contents for Haier DW12-CBE5
- Page 1 Use and Maintenance Manual DW12-CBE5 Code: 0120505955A...
-
Page 2: Close-Up View (Control Panel)
Safety - a good habit NOTICE - If the appliance malfunctions, turn off the water supply to the Carefully read the instructions contained in this manual, as they appliance and disconnect the plug from the wall socket. provide important information which is essential to the safe and Then, consult the section entitled, “Trouble shooting”. -
Page 3: Close-Up View (Interior)
Close-up View (Interior) A Cup Rack G Washing Filter B Upper Rack Detergent and Rinse Aid Dispenser C Rack Height Adjustor I Salt Container Cap D Top Spray Arm J Cutlery Basket E Lower Rack K Knife rack F Bottom Spray Arm Technical characteristics 59.8 cm Width... - Page 4 Salt…… Salt Adjusting salt consumption The hardness of water varies from place to place. If hard water is You can adjust the amount of salt used to suit the hardness of used in the appliance, deposits will form on the dishes and utensils. the water in your area.
- Page 5 Detergent and rinse aid... Detergent Rinse aid Detergent specifically intended for use with dishwashers must This product makes dishes sparkle and helps them to dry with- be used. The dispenser must be refilled before the start of each out spotting. The dispenser is located on the inside panel of the wash cycle following the instructions in the “Wash Cycle Table.”...
-
Page 6: Loading The Dishwasher
Loading the dishwasher Before placing the dishes in the dishwasher, remove larger food Lower Rack Upper Rack particles to prevent the filter from becoming clogged, which re- sults in reduced performance. If the pots and pans have baked-on food that is extremely hard to remove, we recommend that they are soaked before being washed. -
Page 7: Starting The Appliance
Starting the appliance If you forget to load some of the dishes... Switching the machine on ... The wash cycle can be interrupted by opening the door care- After having completed all of the installation steps in the pre- fully (in order to avoid being sprayed by hot water). When the ceding paragraphs, turn on the water to the unit, partially open door is closed again, the cycle will automatically restart at the the door of the dishwasher, and press the ON-OFF button “A”... -
Page 8: Wash Cycle Table
Wash Cycle Table Laboratory measured valve in accordance with European Standard EN50242... -
Page 9: Energy Saving Tips
Energy saving tips --It is important to try and run the dishwasher when it is fully -Use the right amount of detergent: If you use too much detergent, loaded in order to save on energy. In order to prevent odours the result will not be cleaner dishes, but a greater negative im- from forming and food from caking onto the dishes, you can run pact on the environment. -
Page 10: Troubleshooting
Trouble shooting Error messages It may occur that the dishwasher does not function or does not The dishwasher is equipped with a safety system that is able to function properly. Before calling for assistance, use this trouble detect operating problems and malfunctions. These malfunctions shooting guide to see if you can resolve the problem yourself: are signalled by the rapid blinking of one of the program LEDs “F”. -
Page 11: Installation
Installation Positioning the appliance Attention: Positioning the appliance in the desired location. The appliance The special plastic hose support must be solidly fastened to the is equipped with water supply and drain hoses that can be posi- wall to prevent the drain hose from moving and allowing water to tioned to the right or the left of the appliance to facilitate proper spill outside the drain. - Page 12 Installation .11.