Download Print this page

End Of Programme; Switching The Dishwasher Off; Interrupting The Programme - Haier DW12-TFE1 series Operation Manual

Hide thumbs

Advertisement

Table of Contents

End of programme

Six beeps will indicate that the wash cycle has finished and the state indicators "A" light.

Switching the dishwasher OFF

Several minutes after the programme has ended:
Set On-Off button to Off
Open the door .
Turn the water tap off.
Remove dishes, etc. when they have cooled down.
Notice:
When the appliance is already underway press the button "B" for 3 seconds, all of
the settings will be cancelled.

Interrupting the programme

Open the door. Caution! There is a risk of water squirting out from inside the appliance. Do not open
the door fully until spray arm has stopped rotating.
When you open the door, the dishwasher will beep ten times every thirty seconds.
If the appliance has already heated up or the hot water was switched ON and then the appliance door
opened, leave the door ajar for several minutes and then close. Otherwise, the appliance door may
open due to expansion.
Delayed start programming (DW12-TFE3 Series)
You can delay the start of a programme in increments of 1 hour up to 24 hours.
Close the door after loading the appliance.
Switch dishwasher ON.
Immediately press the Delayed Start button " F ", the delayed start indicator " E " blinks, the remain-
ing time indicator " G " changes to "
Press the Delayed Start button for 2 seconds until the numerical display show the required delay.
To cancel the time delay setting, pressing the Delayed Start button until the delayed start indicator
" E" goes out.
Rotate programme knob " J " to select the desired programme.
A
B
".
C
E
H
D F
G
I
Kalt
J
EN
16

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

  Also See for Haier DW12-TFE1 series