Day And Time Announcements - AT&T E5640 - 5.8GHZ Spec Answ System User Manual

91-000353-010-000_E5640_R4.qxd
1.
Press
TIME/SET
The system will announce the cur-
rent clock setting, then announce
is "To change clock, Press TIME
SET!¨
2.
Press TIME/SET
3.
Press CHANGE
until the system announces the cor-
rect day, then press TIME/SET.
4.
Press CHANGE
until the system announces the cor-
rect hour, then press TIME/SET.
5.
Press CHANGE
until the system announces the cor-
rect minutes, then press
TIME/SET.
NOTE: You can press and
hold CHANGE to advance
the minutes in increments of ten.
6.
Press CHANGE
until the system announces the correct
year, then press TIME/SET. The
system announces the current
clock setting.
7/1/2005 12:23 PM
Answering System Operation

Day and time announcements

To set day and time
Before playing each message, the answering system
announces the day and time the message was received.
Before using the answering system, you should follow
the steps at left to set the day and time, so messages
are dated correctly.
The system uses voice prompts to guide you. Each time
you press , the day, hour, minute or year
CHANGE
advances by one. When you hear the correct setting,
press to move to the next setting.
TIME/SET
To check day and time
You can press
TIME/SET
current day and time without changing it.
NOTE: Press and hold
CHANGE
ments of 10 (the year can be set from 2000 to 2039).
NOTE: Caller ID provides the time and date. Set the year so that the day
of the week can be calculated from the caller id information. After you set the
time once, it will thereafter be set automatically with incoming Caller ID informa-
tion. The time will be set automatically only if you subscribe to Caller ID service
provided by your local telephone company (see page 7).
25
Page 25
at any time to hear the
to advance the minute or year by incre-