Table of Contents
Advertisement
.
CLOCK
The system will announce
the current clock setting,
then announces "To set the
clock, press CLOCK."
2.
CLOCK
The system will announce
the current year setting, then
announces "To change the
year, press SKIP or REPEAT,
to change the hour, press
CLOCK."
3.
SKIP or
until the system announces
the correct year, then press
CLOCK.
4.
SKIP or
until the system announces
the correct hour, then press
CLOCK.
5.
SKIP or
until the system announces
the correct minutes, then
press CLOCK.
6.
SKIP or
until the system announces
the correct day, then press
CLOCK. The system announces
the current clock setting.
Answering system operation
Day & time announcements
To set day and time
Before playing each message, the answering system
announces the day and time when the message was
received.
Before using the answering system, follow the steps
on the left of this page to set the day, time and year,
so that messages are dated correctly. If the clock is not
set, before new messages are recorded, the system will
announce "Time and day not set" before each message
is played back.
Caller ID provides the time and date. Set the year
so that the day of the week can be calculated
from the caller ID information. After you set the
time once, it will thereafter be set automatically
with incoming caller ID information. The time will
be set automatically only if you subscribe to caller
ID service provided by your local telephone com-
pany (page 32).
REPEAT
The system uses voice prompts to guide you. Each time
you press SKIP or
year increases or decreases by one. When you hear the
correct setting, press CLOCK to move to the next set-
ting, or press
REPEAT
To check day and time
You can press
rent day and time without changing it.
REPEAT
NOTE: You can press and hold
increase or decrease the minutes or years by increments
of ten.
REPEAT
REPEAT, the day, hour, minute or
/STOP to exit the clock menu.
PLAY
at any time to hear the cur-
CLOCK
36
SKIP or
REPEAT to
Advertisement
Table of Contents
