Chapter 5. Setting up Serial over LAN for the HC10 blade
workstation
Serial over LAN (SOL) provides a means of managing the blade workstation
remotely by using a command-line interface (CLI) over a Telnet or Secure Shell
(SSH) connection.
SOL provides console redirection for both BIOS and the blade workstation operating
system. The SOL feature redirects serial-connection data over a LAN without the
need for special cabling. The SOL connection enables the blade workstation to be
managed from any remote location that has network access. SOL has the following
advantages:
v Remote administration without keyboard, video, or mouse
v Reduced cabling and no need for a serial concentrator
v A standard Telnet interface that eliminates the need for special client software
The IBM BladeCenter management-module command-line interfaces provide
access to the text-console command prompt on each blade workstation through a
SOL connection, enabling the blade workstation to be managed from a remote
location.
Hardware and firmware requirements
The blade workstation is SOL capable. You must configure the blade workstation to
enable SOL operation. The blade workstation supports SOL sessions on VLAN
4095 only; make sure to configure the SOL function to operate on VLAN 4095.
Hardware requirements
For the HC10 Type 7996 blade workstation, SOL uses the Ethernet 1 network
interface (Planar Ethernet) and an Ethernet I/O module in the BladeCenter unit I/O
bay 1 to communicate.
Software requirements
Make sure that you are using the latest versions of device drivers, firmware, and
BIOS code for the blade workstation, advanced management module, and other
BladeCenter components (see the minimum version levels in "Firmware updates" on
page 36). Go to http://www.ibm.com/systems/support/ for the latest information
about upgrading the device drivers, firmware, and BIOS for BladeCenter
components. The latest instructions are in the documentation that comes with the
updates.
General configuration
This section provides instructions for configuring the blade workstation to operate
using SOL, where that information differs from the information in the BladeCenter
Serial over LAN Setup Guide. The BladeCenter Serial over LAN Setup Guide is on
the IBM BladeCenter Documentation CD that comes with the blade workstation. You
can also download the latest version of the guide from http://www.ibm.com/systems/
support/.
© Copyright IBM Corp. 2007
39