Table of Contents
Advertisement
Features and specifications
This section provides a summary of the features and specifications of the blade
workstation. Use the Configuration/Setup Utility program to determine the specific
microprocessor that is in the blade workstation.
Notes:
1. Power, cooling, removable-media drives, external ports, and advanced system
2. The operating system in the blade workstation must provide USB support for the
Microprocessor:
Supports one microprocessor
®
v Dual-core Intel
Core 2 Duo 64-bit
microprocessor
v High performance
v Low power consumption
Note: Use the Configuration/Setup
Utility program to determine the size
of the L2 cache, speed of the
microprocessor, and speed of the
front-side bus.
Memory:
v Dual channel 800/667/533 MHz
DDR2 with four dual inline memory
module (DIMM) connectors
v Minimum: 1 GB; maximum: 8 GB
v Type: Two-way interleaved,
unbuffered non-ECC DDR2,
PC2-5300, SDRAM DIMMs only
v Size: 512 MB, 1 GB, and 2 GB, in
pairs
Drives:
v One internal small-form-factor
pluggable (SFP), SATA International
Organization (SATA-IO) storage
drive
v 60 GB or larger
v 5400 rpm (if hard disk drive) or
faster
6
BladeCenter HC10 Type 7996: Installation and User's Guide
management are provided by the BladeCenter unit.
blade workstation to recognize and use the BladeCenter unit removable-media
drives and front-panel USB ports. The BladeCenter unit uses USB for internal
communications with these devices.
Integrated functions:
v Q965 Express chip set with ICH8
v Broadcom Gigabit Ethernet
controller with TCP/IP offload
engine (TOE)
v Local service processor:
Baseboard management controller
(BMC) with Intelligent Platform
Management Interface (IPMI)
firmware and Serial over LAN
(SOL)
v Local service processor (BMC)
v RS-485 interface for
communication with the
management module
v Automatic blade workstation
restart
v Four USB buses for
communication with keyboard,
mouse, and removable media
drives
Keyboard/video/mouse:
v One of the following
high-resolution video controllers
(graphics cards), depending on
the blade workstation model:
– NVIDIA Quadro FX 1600M (3D)
– NVIDIA Quadro NVS 120M
(2D)
v Support for dual keyboard, video,
and mouse (BladeCenter KVM
and thin client KVM)
v Graphics and I/O Transmission
Adapter (compression card) for
communication with thin client
Electrical Input:
12 V dc
Environment:
v Air temperature:
– Blade workstation on: 10° to 35°C
(50° to 95°F). Altitude: 0 to 914 m
(2998.69 ft)
– Blade workstation on: 10° to 32°C
(50° to 95°F). Altitude: 914 m to
2134 m (2998.69 ft to 7000 ft)
– Blade workstation off: -40° to
60°C (-40° to 140°F)
v Humidity:
– Blade workstation on: 8% to 80%
– Blade workstation off: 5% to 80%
Size:
v Height: 24.5 cm (9.7 inches)
v Depth: 44.6 cm (17.6 inches)
v Width: 2.9 cm (1.14 inches)
v Maximum weight: 4.29 kg (9.46 lb)
Advertisement
Table of Contents
