Table of Contents
Advertisement
A set of blank labels comes with the blade workstation. When you install the blade
workstation in the BladeCenter unit, write identifying information on a label and
place the label on the BladeCenter unit bezel. See the documentation for your
BladeCenter unit for recommended label placement.
If you use bar code labels to track your blade devices, place the bar code label on
the release lever in the location that is shown in the following illustration.
Important: Do not place any label anywhere else on the blade workstation or in
Release
levers
Related documentation
This Installation and User's Guide contains general information about the blade
workstation, including how to install supported optional devices and how to
configure the blade workstation. The following documentation also comes with the
blade workstation:
v Problem Determination and Service Guide
v Safety Information
any way block the ventilation holes on the blade workstation.
User bar
code label
This document is in PDF on the IBM BladeCenter Documentation CD. It contains
information to help you solve problems yourself, and it contains information for
service technicians.
This document is in PDF on the IBM BladeCenter Documentation CD. It contains
translated caution and danger statements. Each caution and danger statement
that appears in the documentation has a number that you can use to locate the
corresponding statement in your language in the Safety Information document.
3
Chapter 1. Introduction
Advertisement
Table of Contents
