Removing the blade workstation bezel assembly
To install certain optional devices, you might choose to first remove the blade
workstation bezel assembly. The following illustration shows how to remove the
bezel assembly.
To remove the blade workstation bezel assembly, complete the following steps:
1. Read the safety information that begins on page v and "Installation guidelines"
2. Open the blade workstation cover (see "Opening the blade workstation cover"
3. Disconnect the control-panel cable from the control-panel connector.
4. Press the bezel-assembly release and pull the bezel assembly away from the
5. Pull the bezel assembly completely away from the blade workstation.
6. Store the bezel assembly in a safe place.
18
BladeCenter HC10 Type 7996: Installation and User's Guide
Bezel-assembly
release
on page 15.
on page 17 for instructions).
blade workstation approximately 1.2 cm (0.5 inch).
Bezel-assembly
release
Bezel
Control-panel cable
Control-panel connector