IBM 9228 - IntelliStation Z - Pro Installation Manual page 43

Table 2. POST error codes (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem
is solved.
v See the part listing in the Problem Determination and Service Guide to determine which components are
customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a
trained service technician.
Error code Description
178x An error occurred during the hard disk drive
x test (x = 0 to 3).
1800 No more hardware interrupt available for the
PCI adapter.
1808 Unsupported PCI device is installed.
Action
1. Reseat the hard disk drive x cable.
2. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Hard disk drive x
b. Hard disk drive cable x
c. (Trained service technician only) System board
1. Run the Configuration/Setup Utility program.
2. Remove the adapter.
1. Run the Configuration/Setup Utility program, select
Devices and I/O Ports, and make sure that the
device is enabled.
2. Reseat each adapter.
Note: If an error LED is lit on an adapter, reseat
that adapter first; if no LEDs are lit, reseat each
adapter one at a time, restarting the computer
each time, to isolate the failing adapter.
3. Replace the following components one at a time,
in the order shown, restarting the computer each
time:
a. Failing adapter
b. (Trained service technician only) System board
Chapter 5. Solving problems
31