Power And Signal Cables For Internal Drives - IBM 9228 - IntelliStation Z - Pro User Manual

1. Read the safety information that begins on page v and "Installation
guidelines" on page 29.
2. Turn off the computer and peripheral devices; then, disconnect all external
cables and power cords.
3. Unlock the side cover. The bezel will not disengage from the computer if the
cover is locked. You do not have to remove the side cover.
4. Remove the lower bezel (see "Removing the two-piece bezel" on page 36).
5. Touch the static-protective package that contains the hard disk drive to any
unpainted metal surface on the computer; then, remove the drive from the
package and place it on a static-protective surface.
6. Align the drive assembly with the guide rails in the bay (the connector end of
the drive goes in first).
7. Pull the loops of the drive assembly toward each other; then, carefully slide
the drive assembly into the drive bay until the drive assembly connects to the
back panel connector at the rear of the drive bay (you should hear a click).
Note: Do not release the loops on the drive assembly until the drive
assembly is completely seated.
If you have other options to install or remove, do so now. Otherwise, replace the
two-piece bezel (see "Replacing the two-piece bezel" on page 57) and the side
cover if removed (see "Replacing the side cover" on page 59).

Power and signal cables for internal drives

Important: This computer is suitable for use on an IT power distribution system
whose maximum phase to phase voltage is 240 V under any distribution fault
condition.
The computer uses cables to connect IDE, SATA, and SAS devices to the power
supply and to the system board. See "System board internal connectors" on page
33 for the location of system-board connectors. Review the following information
before connecting power and signal cables to internal drives:
Chapter 4. Installing options
47