Table of Contents
Advertisement
NETGEAR ProSafe 802.11g Wireless Access Point WG102 Reference Manual
•
Authentication/Access Control Radius Server Configuration. This configuration is
required for authentication using Radius. IP Address, Port No. and Shared Secret is required
for communication with Radius Server. A Secondary Radius Server can be configured which
is used on failure on Primary Radius Server
•
IP Address. The IP address of the Radius Server. The default is 0.0.0.0.
•
Port Number. Port number of the Radius Server. The default is 1812.
•
Shared Secret. This is shared between the Wireless Access Point and the Radius Server while
authenticating the supplicant.
•
Re-authentication Time. The time interval in seconds after which the supplicant will be
authenticated again with the Radius Server. The default is 3600 seconds.
•
Global-key Re-Key Time. Check on this option to enable Re-keying of Global Key. The
Global Key Re-Key can be done based on time interval in seconds or number of packets
exchanged using the global key. The default is 3600 seconds.
•
Update if any station disassociates. Check on this option to refresh global key when any
stations disassociated with wireless Access Point.
•
Accounting Radius Server Configuration. This configuration is required for accounting
using Radius Server. IP Address, Port No. and Shared Secret is required for communication
with Radius Server. A Secondary Radius Server can be configured which is used on failure on
Primary Radius Server.
•
IP Address. The IP address of the Radius Server. The default is 0.0.0.0.
•
Port Number. Port number of the Radius Server. The default is 1813.
•
Shared Secret. This is shared between the Wireless Access Point and the Radius Server while
authenticating the supplicant.
Configuring Network Authentication
Follow the steps below:
1. Connect to the WG102 Access Point.
Log in at the default LAN address of http://192.168.0.229 with the user name of admin and
default password of password, or using the LAN address and password that you set up.
2. If you are using Radius Server Settings, set them up first, as described in
Radius Server Settings" on page
2-8
2-7.
v1.0, July 2008
"Configuring the
Configuring Security
Advertisement
Table of Contents
