Rear Panel; Cabling Requirements - NETGEAR WAG102NA Reference Manual

NETGEAR ProSafe 802.11g Wireless Access Point WG102 Reference Manual
LED Description
LAN Ethernet link indicator
Off
Amber On
Amber Flashing
Green On
Green Flashing
WLAN Wireless LAN Link Activity Indicator
Off
Green Blink

Rear Panel

2
1
Figure 1-2
Viewed from left to right, the back of the WG102 provides the following:
1. Detachable antenna.
2. Ground.
3. Reset button. This restores the default factory settings.
4. RJ-45 Ethernet LAN/POE Port. Use the WG102 Ethernet RJ-45 port to connect to an Ethernet
LAN through a device such as a hub, switch, router, or Power Over Ethernet (POE) switch.
5. Power socket. This connects to the WG102 power adapter.

Cabling Requirements

The WG102 Access Point connects to your LAN via twisted-pair Category 5 Ethernet cable with
RJ-45 connectors.
Basic Installation and Configuration
No connection detected on the Ethernet link
10 Mbps Ethernet link detected
Data is being transmitted or received on the 10 Mbps Ethernet link
100 Mbps Fast Ethernet link detected.
Data is being transmitted or received on the 100 Mbps Ethernet link
No wireless link activity.
Wireless link activity.
3 4 5
v1.0, July 2008
1-3