Table of Contents
Advertisement
NETGEAR ProSafe 802.11g Wireless Access Point WG102 Reference Manual
•
The WG102 Access Point is properly installed, LAN connections are OK, and it is powered
on. Check that the LAN port LED is on (amber indicating a 10 Mbps Ethernet connection or
green indicating a 100 Mbps Ethernet connection) to verify that the Ethernet connection is
OK.
•
The default configuration of the WG102 is for a static IP address of 192.168.0.229 and a Mask
of 255.255.255.0 with DHCP disabled. Make sure your network configuration settings are
correct.
•
If you are using the NetBIOS name of the WG102 to connect, ensure that your computer and
the WG102 are on the same network segment or that there is a WINS server on your network.
•
If your computer is set to "Obtain an IP Address automatically" (DHCP client), restart it.
•
If your computer uses a Fixed (Static) IP address, ensure that it is using an IP Address in the
range of the WG102. The WG102 default IP Address is 192.168.0.229 and the default Subnet
Mask is 255.255.255.0.
When I Enter a URL or IP Address I Get a Timeout Error
A number of things could be causing this. Try the following troubleshooting steps.
•
Check whether other PCs work. If they do, ensure that your PCs TCP/IP settings are correct. If
using a Fixed (Static) IP Address, check the Subnet Mask, Default Gateway, DNS, and IP
Addresses.
•
If the PCs are configured correctly, but still not working, ensure that the WG102 is connected
and turned on. Connect to it and check its settings. If you cannot connect to it, check the LAN
and power connections.
•
If the WG102 Access Point is configured correctly, check your Internet connection (DSL/
Cable modem etc.) to make sure that it is working correctly.
•
Try again.
Using the Reset Button to Restore Factory Default Settings
The Reset button (see
•
Reboot. When pressed and released quickly, the WG102 will reboot (restart).
•
Reset to Factory Defaults. This button can also be used to clear ALL data and restore ALL
settings to the factory default values.
Troubleshooting
"Rear Panel" on page
v1.0, July 2008
1-3) has two functions:
5-3
Advertisement
Table of Contents
