Factory Default Settings And Specifications; Factory Default Settings - NETGEAR WAG102NA Reference Manual

Factory Default Settings and Specifications

Factory Default Settings

When you first receive your WG102 Access Point, the default factory settings are set as shown
below. You can restore these defaults with the Reset button on the rear panel — see
on page 1-3.
Feature
User name (case sensitive)
Password (case sensitive)
Operating mode
Access point name
Built-in DHCP client
IP configuration
Network Name (SSID)
Broadcast Network Name (SSID)
Super-G mode
WEP/WPA
MAC Access Control
Restricting connectivity based on MAC Access
Control List
Time Zone
Time Zone Adjust for Daylight Saving TIme
SNMP
VLAN (802.1Q)
WMM support
Factory Default Settings
admin
password
Access point
netgearxxxxxx where xxxxxx are the last six digits of the
wireless access point's MAC address
DHCP client disabled, it uses the default IP address
IP Address: 192.168.0.229
Subnet Mask: 255.255.255.0
Gateway: 0.0.0.0
NETGEAR-0-0
Enabled
Disabled
Disabled
Disabled
Disabled
GMT
Disabled
Disabled
Disabled
Disabled
v1.0, July 2008
Appendix A
"Rear Panel"
A-1